Diode-Pumped Solid-State Micro Laser

Home/Lasers and Laser Systems, Solid-State Lasers, standa/Diode-Pumped Solid-State Micro Laser

Diode-Pumped Solid-State Micro Laser

532 nm wavelength micro lasers with short pulses, high peak power together with high reliability.

High peak powers with sub-nanosecond pulse lengths or high repetition rates at wavelengths 532 nm and are now available from Standa. This family of highly reliable, solid-state lasers consists of a power supply unit and laser head. The power supply unit includes a laser diode (LD) driver, fiber pigtailed LD, and internal pulse generator. The laser repetition rate can be operated in three different modes, and set by STANDA from single pulse or to max repetition rate agreed with customer in either pulsed LD pumping mode. STA-01SH – produces pulses of second harmonic.

  • TEM00 and pulsed spectral structure SLM


  • Pump source for harmonic generators,optical parametric oscillators and amplifiers(using periodically poled KTP or LiNbO3 crystals)
  • Low-coherence “white light” interferometry
  • Test and measurement systems
  • Optical coherence tomography
  • Two-photon microscopy
  • Fluorescence microscopy
Models STA-01SH-1 STA-01SH-2 STA-01SH-3 STA-01SH-4
Wavelength, nm 532
Average output power (max), mW 40 25 50 20
Pulse energy, µJ 4 5 50 0.2
Pulse width (FWHM), ns 0.5 < 0.7 0.5 0.5
Repetition rate (max), kHz 10 5 1 100
Beam Profile M2 < 1.1
Pulse spectral structure single longitudinal mode
Polarization ratio > 100:1
Beam Waist diameter inside the laser head 1/e2, µm* 25-200
Pulse spectrum FWHM, pm < 5 (near transform limited)
Pulse to pulse energy stability RMS < 0.5
Power stability over six hours** < ± 1,5%
External power supply voltage, V AC 100-240
Operating temperature, °C 22±1 1 , non-condensing
Interfaces USB, External trigger (TTL rising edge) 1HZ…max repetition rate
Laser head dimensions:
  diameter, mm 25
  length, mm 76.5

1 – Is specified an ambient temperature at which the laser parameters exactly meet the specifications in the table.

Specifications are subject to changes without advance notice.

*Waist position depends on model
** After 5 to 10 minutes warm-up and temperature variation of <±3 °C and <3 °C/hour.


There are no reviews yet.

Be the first to review “Diode-Pumped Solid-State Micro Laser”

Your email address will not be published. Required fields are marked *

Go to Top